Every command will be saved in the actual profile. You can choose every name – but note that you need clear names if you want to control more than one program via remote. You can open, edit and delete commands and complete profiles on the simpliest way.You can lock you specified profile if you need. You can load, edit and save your personal profiles. Miriam has a lot of features and windows which need a few descriptions. The question mark changes to a remote control which blinks red if a key is pressed.Now you can work with this configuration. If the COM-port is correct, please confirm it again (otherwise it will be buggy after restarts). Confirm the error message and go on the question mark in your task menu and open “Receiver Setup”.Connect the receiver with your PC now, wait a moment for installing the driver and take a short look in your device manager on which COM-port a virtual COM-port is generated. Miriam answers “Error while opening COM-port.Install “miriam_irman.exe” in your preferred folder and start Miriam.Please remove the USB-receiver from your PC.Thereby Miriam has provided definined characteristics for both modules. The Miriam OR Girder - software is needed, to convert the button presses on your remote control into keystrokes in your programs. Then you go to the next step -) Uninstall of IR-2-usb Note the COM port-NUMBER you still need the 'address' in order to configure to Girder correctly! Your PC discovers in the device manager under the USB bus a further serial interface now.The structures of W2K and Win XP are almost identical, this error message can be ignored.) (you get an warning message from WindowsXP now. First download the USB drivers and save it on a disk, before you begin the installation! Download.Then you go to the next step -) Installation of IR-2-usb under W2K / WinXP Your PC now discovers a further serial interface in the device manager under the USB bus.Please select 'Searching for the best Driver' and as drive 'floppy drive'.The hardware recognition starts automatically (if not, please go to control panel and click on 'Hardware') You are coming now in the installation routine, where you are asked for the driver.
Connect the module using an A/B cable to the USB-port of your PC.First download the USB drivers and save it on a disk, before you begin with the installation! Download.Installation of IR-2-usb under Win98 / WinME